Woodworking band saw blade experience

1, the choice of models is very important:

The quality of the horizontal sawing, the life of the saw blade and the choice of the model are very important. If you are only processing the sheet below the 250mm width, please select the 250 type machine, do not select the 250 or more models.

Because the closer the saw clip is to the wood, the higher the quality and stability of the wood processing, the longer the time of use and the fastest speed.

If the distance between the two saw clips is wider, the swarf will be distorted during the wood processing process, resulting in a higher probability of cornering, and twisting and running will increase the load on the saw blade and cause the saw blade to break.

2, saw blade, saw blade has a bend, wave:

1 The main reason is the unsatisfactory production of saw blades;

2 The tooth pitch and angle do not match the sawn timber;

3 Saw blade is not sharp;

4 Saw clips are changed or adjusted.

3, saw blade life is short, easy to crack (in addition to the aircraft does not match the reasons):

1 The poor quality of the saw blade steel plate is the main reason; the imported special steel band has a higher tensile strength than the domestic low-end steel band and has a long service life.

2 The pitch and angle of the tooth pitch are not consistent with the sawn timber. The timber requires a small tooth pitch and a small rake angle, whereas the wood is soft and requires a large tooth pitch and a large rake angle.

3 The saw blade is not sharp and overloaded. It must be ground and lightly ground to keep the blade sharp.

Company Profile Products News Center Video Center Feedback Recruitment Contact Us