Woodworking strip pressing method

Carpentry with the strip of rolling method:

l Press the convex surface first, and check the strip with a flat rule to see if there is congenital unevenness, if any, then press the convex surface first.

2, from the beginning of the middle, separated by 8 to 10 mm before and after the jump pressure, the intensity is gradually reduced to the middle of the two sides, leaving 15 mm tooth root belt. While checking the arc with a ruler, do not exceed the limit. At the same time check the back of the trimmer blade, no bending is allowed.

3. After completing one side, then turn the saw blade over to check if there is any missing area on the other side. If there is, continue pressing, but be sure to note the pressure along the roller. Never misbehave. After the criteria are met, check the trimming step by step. The trim must also be printed along the roller. After the anti- and front-facing standards are met, the batten is completed.