Run-in of bimetal band saw blade

   The service life of the band saw blade has a lot to do with the correct running-in when the band saw blade is used. The following running-in conditions are suitable. After the normal cutting speed and the correct number of teeth have been determined, the initial cutting speed is 70% of normal cutting speed and 50% of normal feeding. After sawing about 400-600 cm2 of area, it can gradually increase to normal speed and feed.

Comprehensive tips:

The following factors affect the sawing effect and the service life of the band saw blade:

>> Selection of coolant

>> Sawing wire brush

>> Tension with band saw blade, recommended value is 300N/mm2 (Newtons/mm2)

Safety requirements:

The welded finished tape to the user is coiled and tensioned. Therefore, when opening the finished tape and installing it on the sawing bed, the following safe operating procedures must be observed:

>> Wear protective glasses

>> Wear work gloves

>> Put on work shoes

Under normal circumstances, there are more detailed descriptions in the operating instructions of the sawing machine.